The 15 ton tanker approved for 15 ton capacity is a large-scale work vehicle. It can carry up to 15 tons of various types of oil at a time. However, during the long-term transportation of oil products, there will be a problem. Because of the viscous deposit of the oil itself, or due to the influence of the outside world's lower temperature, the oil in the tank is often more viscous and the fluidity is greatly reduced. When the oil is drained, it is difficult to release the oil from the oil. In this case, the tanker now needs to be loaded with a dedicated local refueling tanker, which can quickly heat up the tank for local treatment, thus allowing the oil to resume high fluidity.
How does this fast accelerator work? In a 15 ton oil tanker, a vortex heat film heat exchanger is usually installed. It is placed directly along the bottom of the oil tank. High heat steam flows through the heat exchanger and passes through the steam. The continuous flow inside, effectively recovers the fluidity of the oil inside the tank, allowing the viscous oil to flow again.
And this kind of heat exchanger has a special temperature control valve, which can effectively measure the temperature of the oil inside the oil tank through the above temperature sensor effectively, effectively allowing everyone to control the temperature at the oil outlet. The oil temperature can be effectively stabilized.
After using such a heat exchanger, the oil output of a 15 ton tanker can be made simpler and more convenient. In particular, the heat exchanger has a high heating speed and a high heat transfer efficiency. Grease is very convenient to use. In particular, it can be heated quantitatively to control the temperature, heating, how long it takes, and how long it takes to refuel, can be manually operated, so that everyone can need how much to heat, very convenient, The temperature control also avoids the occurrence of local excessively high temperatures and charring problems in the tank, and better guarantees that the quality of the oil is not affected.
The SP Sump Slurry Pump is designed for coal preparation, chemical handling, minerals processing ,sand and gravel and general tank, pit or hole-in-ground slurry applications. The cantilever design makes the SP Sump Pump ideally suited for heavy continuous handling of abrasive, coarse grained particle and corrosive liquids and slurries while submerged in sumps .They can also work normally under intermittent feeding. The wet parts are designed with hard metal, so offer you reliability and long wear life.
Product Feature
1.Vertical, centrifugal and single casing structure.
2.The Impeller is double suction half-open structure, is made of wear-resistant alloy.
3.No submerged bearings or packing.
4.Available in various standard lengths to suit common sump depths, a suction extension pipe can be fitted to the bottom inlet to extend the depth of the pump.
5.Three type construction of the pump inlet: standard type with strainer, suction pipe with strainer,with agitator.
6.Direct drive, V-belt drive could be selected to connect with the drive.
SP Sump Slurry Pump
SP Sump Slurry Pump,Lengthening Sump Slurry Pump,Vertical Centrifugal Sump Slurry Pump,Single Casing Sump Slurry Pump,Metal Sump Slurry Pump
Shijiazhuang Soarho Machinary Co.,Ltd , https://www.xhslurrypump.com