1 Scope
This regulation stipulates the safe operation content and requirements of the electrolyte circulation post.
This procedure is applicable to the electrolyte circulating work of the wet smelting workshop.
2 content
1. Before you go to work, you must wear protective helmets, overalls, protective shoes, protective gloves, protective glasses and other labor insurance products.
2. When there is a driving operation, it is forbidden to work or stay under it.
3. When working at the bottom of the tank, pay attention to the brackets, pipes, trenches and other items at the bottom of the tank to prevent the head from falling or falling into the pits and trenches.
4. When adding electrolyte to the electrolyzer, it is strictly prohibited to operate the sputum; the valve should be opened slowly or slowly, and the person's head should be slightly sideways.
5. When working with additives, heat exchangers or steam systems, take care to prevent steam burns.
6. Check the rectifier according to the operating standard, find the problem and stop the power according to the standard in time, and report it immediately.
7. Stop and open the pump and filter press according to the operating standards.
8. When switching the valve, be careful not to open or close too much, causing the interface flange to loosen or the gasket to rupture and a liquid spray accident.
9. When repairing the electrolyte pipe, steam pipe or air duct, the “no operation†card should be hung on the corresponding valve and pump.
10. Strictly abide by the system of stopping the operation of water, steam, wind and electricity.Stretching Roller,Roll For Stamping Machine,Printing Machine Rubber Roller,Roller For Stamping Machine
Taixing Jinlong Rubber Rollers Co., Ltd. , https://www.txjinlongrubber.com