The speed of pumping the oil tanker is getting slower and slower. Is the pump broken? What is the reason? Everyone knows that any oil or oil transported by oil tankers is not an exception during transportation or production. When the tanker is used for a period of time, the front-end fuel tanker pump tubing three-way filter plugs these impurities and blocks the oil filter. It can make the oil pump slower, so we need to establish a habit of regularly cleaning the time tanker filter, which can effectively solve the slow failure of the tanker pump. Sometimes the tanker valve will attach the remaining oil in the tank. Our tanker driver is not very open when opening the ball valve, which will also cause the tank pump to slow. Of course, any good machine will be in trouble after being used for a period of time, so we cannot rule out the slowdown of the oil pump that damages the tanker. At this time we can follow the following quality inspection methods: open the ball valve, tanker tank oil gravity for a while , Observe the amount of oil, and then open the tank to see if the pump oil level changes. When the tanker is in a stopped state, it is relatively easy to turn the shaft of the oil pump by hand. If the shaft rotates, the pump will be stuck and there will be difficult transitions. Internal gear pump, burn. Need to repair oil pump, oil pump replacement. We strictly use the tanker in accordance with the normal manufacturer's operating methods. After a period of time, it is normal for the pump to be slow. As long as we regularly check the three filters of the tank truck, we can also solve it here. We also remind users here that it must be installed on the tanker truck. The filter, do not try to remove the picture by the speed, which will damage the pump. Remarks: Most of the pumps are gear pumps. The gear pump has two closely fitting gears. These two gears are made of high-density nylon fibers because the fibers do not generate static electricity when they rub against each other, and the idler fibers do not exist when the pump body has no oil. It will be deformed because the temperature is too high. Therefore, do not allow the pump to idle without oil.
Submersible Pumps,High Pressure Pump,Electric Water Pump
Surface Pumps Co., Ltd. , http://www.nssurfacepumps.com