Car use tips

★ Car use tips ★

Tips (1)
How to eliminate the vibration and noise of the wiper blade: Use pliers to reduce the gap between the joints and the rubber sheet.
Tips (2)
How to extend lamp life: After buying a car or replacing a new one, wipe the lamp with alcohol to eliminate fingerprints and oil.
Tips (3)
How to reduce tire noise: Stick a layer of black felt cloth or flannel on the front wheel inner protection plate. (After careful experience, your tire noise becomes smaller after raining, and it becomes larger after washing, because there is mud noise on the inner protective plate).
Tips (4)
How to extend the life of the muffler: Make a hole in the lowest point below the muffler. The reason is simple: Drainage protects against corrosion.
Tips (5)
How to get started faster: In the case of no-load or low-load vehicles, start directly with the second gear (do not worry about damage to the vehicle, because a gear and clutch are designed under heavy load, and most of the car one The second gear is not smooth. After rushing more than 3,000 rpms, it will be pushed into the third gear quickly, and then rushed to more than 3,000 rpm. At this time, the general car will lag behind you. It is easy to switch between the fourth gear and the fifth gear. It can also be changed directly. To five stalls.
Tips (6)
How to improve the air circulation and defrosting effect in the car: Replace the dust filter element (inside the engine compartment) with a sponge of the same size, which increases the amount of air intake, can be used for washing and reusing, and the defrosting in the car in winter is very fast. Do not have to open the fan, while saving fuel.
Small Door (7)
What to do if you feel that the brakes are not as good as before: When you wait for a red light, step on the brakes a bit and you'll see it.
Tips (8)
How to simply prevent the vehicle from running out of direction: 1. Adjust the tire pressure in the front wheel of the deviation direction or the tire in the other direction to decrease the air pressure; 2. Adjust the toe in the specified range.
Tips (9)
How to prevent the water from the external reversing mirror: Make a small hole under the reversing mirror (bigger it is no harm). Because the sports car immediately after each car wash, the mirror will have water sprinkled on your body, it is annoying.

Indoor Enclosure Air Conditioner

Cabinet Air Conditioner

The indoor enclosure air conditioner have been designed to cool electrical enclosures to prevent failure of installed equipment. Electrical Panel Air Conditioner are quick and easy to install with a standard surface mounted arrangement (a kit can also be bought to allow a semi-recessed installation should the site require it). Once installed the enclosure can be rated to IP54, which prevents dust entering in sufficient quantities that may cause interference with the installed equipment, and prevents damage from splashed water

cabinet ac (5)

The cabinet air conditioning refrigerates the air through inside and outside two independences, and exchanges the heat inside the cabinet to the outside by the heat-exchanger. By this way, it can protect the electricity wind chest's electrical element in the controllable temperature range movement. Simultaneously the cabinet air conditioning has dehumidifies the function, which will guaranteed the cabinet interior has the ideal temperature and the humidity.
working Prinple

Products Features:

  • P54 protection rating – more info on IP ratings
  • Easy installation
  • Electronic controller
  • Temperature control with ON/OFF adjustment
  • Ability to interface with PLC`s
  • Alarm contacts
  • Minimal maintenance
  • Ozone friendly R1134a or R407C refridgerant




Side Mounted Cabinet Air Conditioner,Side Mounted Air Conditioner,Electrical Panel Air Conditioner,Side Mounted Control Cabinet Air Conditioner

Taizhou Tentcool Electrical Appliance Co., Ltd. , https://www.tentcool.com

Posted on